Roll over image to zoom in
Onduleur Mercury 1200 VA Elite Pro
65.000 CFA
Cet onduleur fournit une alimentation par batterie temporaire, en cas de panne de courant
Analyse des pannes de batteries avec alerte précoce, permettant ainsi d’effectuer à temps une maintenance préventive. En plus de cela, cet onduleur est un régulateur de tension.
Caractéristiques techniques Mercury 1200 VA
• Auto restart
• Built-in AVR
• Surge protection
• Dataline protection
• Overload protection
• Overcharge protection
• Short circuit protection
• Intelligent battery management
• Battery deep discharge protection
| Input voltage | 220VAC |
| Input frequency | 50Hz |
| Input phase | Single phase |
| Input socket | With Fuse |
| Cold Start (0 to 100% load) | Press the ON/OFF switch |
| Input range (220V) | 140-300 |
| Rating output (VA). | 1200VA |
| Rating output (W). | 720W |
| Waveform | Battery mode(simulated sine wave),AC mode(sine wave) |
| Power factor | 0.6 |
| Rating voltage | 220V |
| Output range | 220Vac-7% to +15% in battery mode |
| Rear Output Socket | 4 x Universal – Battery backup |
| Transfer time | TYPICAL4-8ms |
| Communication Interface | optional RS232/RJ11 |
| Rating frequency | 50Hz |
| Line-mode | Synchronize with the Utility |
| Battery mode | 50 Hz±1Hz |
| Line Mode | FUSE& firmware protection |
| Battery Mode | Software protection controlled by firmware |
| Line Mode | 110%±5%; Go to fault mode after 5 minutes, 120%±5%; Go to fault mode immediately. |
| Battery Mode | 110%±5%; Shutdown after 5 seconds, 120%±5%, Shutdown immediately |
| Rating | 2 X 12V/7.5AH (Actual rating 7AH) |
| Backup time – Typical | 20 to 30 mins (depending on load) |
| Charge current | About 1A at normal mode. |
| Over charge protection | 29V±0.2V stop charging, 27.4+/-0.2V recharge |
| Weight | 8.6+/-0.3 Kg |
| Dimensions per unit packaging | 395x205x258mm |
| Packsize per Master carton | 2 |
| Dimensions per Master carton | 410x430x273mm |
